MIL-C-21676 Mine Case Mark 36 Mod 2

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10

MIL-C-21679(NOrd)

4.3.2 Preproduction and periodic production tests. -

Preproduction and periodic production tests are those per-

formed on samples submitted in accordance with 4.1.2 and

4.1.4 to determine that the lot and production meet all the

requirements of this specification. Acceptance shall be

based on no defects in a sample. Acceptable preproduction

and periodic production sample units, shall not be released

for service use and shall be stamped or marked as follows:

"Sample - Not for service Use".

4.4

Test equipment.

4.4.1 Test and inspection equipment and facilities. -

Unless otherwise specified. the manufacturer shall furnish

and maintain all necessary test equipment, facilities and

personnel for performing all acceptance tests under the

supervision of the Government inspector The test equipment

shall be adequate in quantity, and unless definite require-

ments are specified, they shall be of sufficient accuracy

and quality to permit performance of the required accept-

ance tests.

4.4.1.1 Equipment required for performing the electri-

cal tests is as follows:

(a) Test Set Mark 95 Mod 1 or megohmmeter - 500 volts

d-c range 10.0-100 megohms, accuracy within �10 percent.

(b) One (1) four channel graphic recorder, chart speed

accuracy within �1.0 percent.

�5 percent.

4.5 Test condition. - Unless otherwise specified, tests

shall be performed at 80� � 15� F and ambient relative hum-

idity.

4.6 Acceptance tests. - Unless otherwise specified,

the manufacturer shall devise procedures and methods satis-

factory to the Bureau of Ordnance for conducting the accept-

ance tests specified herein- The right is reserved by the

Bureau of Ordnance or the Government inspector to modify the

tests or require any additional tests deemed necessary to

determine compliance with the requirements of this specifi-

cation, the drawings, or the contract.